
Hello! I’m passing by to share easy paper pieced cards ideas using the Zero-Waste Ornamental Winter Die , the Elegant Bows Embossing Folder, and Sleigh Ride Greetings.
Video
If you love detail, texture, and using every single die-cut piece with no waste, this project is for you!
Card Recipe
- Zero-Waste: Ornamental Winter Pattern Die
Available at [ Altenew ] and [ SimonSaysStamp ] - Elegant Bows
Avialbel at [ Altenew ] and [ SimonSaysStamp ] - Sleigh Ride Greetings
Available at [ Altenew] and [ SimonSaysStamp ]
Crafty Necessities Cardstock used:
- Parrot
- Volcano Lake
- Lagoon
- Bamboo
- Pumpkin Pie
- Evergreen
- Vineyard Berry
- For the embossed bow, I used Champagne Gold Mirror Cardstock.
Step-by-Step Instructions
It’s much easier to do than it is to explain!

- Die-Cut the Colored Panels
Start by cutting C6-sized panels (5½” x 4¼”) from Volcano Lake and Lagoon cardstock.
Position the intricate inlay die from the Zero-Waste Ornamental Winter Die Set towards the lower center of each panel—this leaves space at the top to add the decorative bow later. Die-cut and set aside the small negative pieces (you’ll use these for paper-piecing). - Create the White Frame Panel
Using the circle outline die from the same set, die-cut a circle from a C6-sized white cardstock panel. Try to align the placement so it matches the inlay die position on the colored panels. - Assemble the Base Layers
Adhere the white die-cut panel over the colored panel, aligning the openings so the negative space frames the inlaid pattern perfectly. Trim any overhang if needed. - Add a Backing Layer
Attach a full C6 piece of Pumpkin Pie cardstock to the back of your panel. This adds a warm contrast behind the intricate design. Again, trim any excess if needed. - Prepare for Card Assembly
These finished decorative panels should be slightly smaller than your card base (also 5½” x 4¼”) to allow for a clean edge when mounted. - Glue the negative die-cuts in the negative spaces of the ornament.
- Emboss a piece of gold mirror cardstock using the Elegant Bows Embossing folder and die-cut with the coordinating die.
- Use a dimensional foam adhesive to affix the bow at the top of the ornament.
- Optional – Add a metallic threat to give the illusion that the ornament is hanging off the page.

When it comes to colour, the sky’s the limit!
You can go bold with a multicoloured composition like the card above or, for a more subtle look, try a low-contrast paper-pieced design using just a few similar or closely related cardstock colours ( like I did for the card below)

This approach makes the most of the backing layer, especially in tiny negative spaces where paper-piecing can be tricky. Either way, the result is beautifully textured and full of depth.
Remember, this is just one idea, you can also use the inlaid die-cut pattern as a background for a festive composition or repurpose the ornaments to create unique tags.

That’s all for today.
thanks for stopping by.
X Bibi

Thirsty for More?
Supplies
Affiliate links apply at no extra cost to you. Thanks for your support.

Leave a Reply